Before you can install a ceiling fan, you need to fit the fan to the size of the room. For a room where the longest wall is 12 feet or less, a 36 inch fan or smaller is best. A room that is 12 to 15 feet wide should have a ceiling fan between 42 and 48 inches. If the rooms longest wall is more than 15 feet, then 52 inches or larger will be recommended.
Before beginning any project, always read the manufactures instructions. A permit may be needed for some local building codes. If at anytime you don’t feel comfortable working with electricity, then contact a licensed electrician.
- Metal Electric Ceiling Box or Expandable Bracket
- Wire Strippers
- Wire Connectors
- Electrical Tape
- Circuit Tester
- Screw Driver
- Drill with Driver and Bit
- Safety Glasses
For instructions on installing an expandable mounting bracket click here.
If you are replacing a ceiling fan then go here.
Turn off the power to the existing light at the breaker box.
Remove the fixture’s canapy. Test the wires with a circuit tester to see if they are still live. If you are sure the electricity is off you can proceed to remove the fixture.
Step 3 (optional, may not be required)
If the existing electric box is plastic, replace it with a metal box; rated for a ceiling fan.
Also, if your box is not securely fastened, you may have to install an expanding mounting bracket. See here. Check the manufactures owners manual before continuing. Every ceiling fan is different, so make sure you are ready to continue. The bracing is very important!
Have the wires hang down for easy wiring.
The next step is to secure the ceiling fan’s bracket to the metal electrical box in the ceiling, with mounting screws and lock washers. There is two basic types the standard ceiling installation using the downrod with ball and socket mounting and the close-to-ceiling (flush mount). The “close-to-ceiling” installation is recommended in rooms with less than 8-feet ceilings or in areas where additional space is desired from the floor to the fan blades. When you flush mount a ceiling fan, you leave out the rod and directly attach the motor assembly to the mounting bracket instead.
Assemble the fan. It is easier to do this if done on the ground. Pull the wires through the down rod canopy or trim. Secure the down rod (if using one)to the housing with the connector pin an cotton pin. Tighten all set screws (may be more then one).
At this stage, don’t attach the fan blades. It will be easier to install.
Lift the assembled unit to the mounting bracket. There will be a hook or half circle to rest the ceiling fan on.
Wire the same color wires together. Attach the white neutral and green ground wires together. If the ceiling fan comes with lights, attach both remaining wires to the hot (black) wire in the box. Tuck the wires inside the electrical box. and seat the canopy with the included screws.
Use wire nuts to securely attach the wires together. Then wrap them with electrical tape.
Now you can attach the fan blades with the supplied screws and washers. Follow the manufactures instructions to install the light.
Turn the power back on and enjoy.